Slicer Discord
Tubes for Geordi Laforge Visor – 3D printable model from Thingiverse Thingiverse

Tubes for Geordi Laforge Visor

by dude2k5
26 Downloads
14 Likes
1 Makes
Go to Model
The original by DrewSmith007 is awesome. Props, great work.

Im just super lazy, didn't want to go to the store so I made 3d printed tubes for the visor. They are snug, but they fit. I didnt even need to use glue, they held well. But you may want to put them in on one side, then put them in on the other (to make sure both ends fit properly inside the holes) and it should work when you put them together

Print 1 to make sure it fits properly, takes like 4 minutes. If you feel dangerous, print like 25 at a time, takes an hour at 10% infill. Use a brim to make them stick better to the heat plate. Cut off the brim after as they may add too much for the visor holes.

I might buy the rods later, but they are too pricey on amazon. This cost me around 22 cents to print them (50)
Source
Thingiverse
What you need to print this: Intermediate Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
PLA
Post-processing
Gluing
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection