Thingiverse
Tulip - Springy Flower Collection
von lglauberman
57
Downloads
157
Likes
0
Makes
This is a Tulip that is compatible with my springy flower collection found here: https://www.thingiverse.com/thing:6861891
The dirt snaps into the planter, the stem(s) screws into the dirt and the tulip screws onto the stem.
Do not scale down or the threads will not work! Print at a fine layer height such as .16mm.
I recommend the springy dirt be made out of ABS with 3 wall loops if possible or it might sag over time.
No supports are required.
The models shown were printed with ABS using a .16mm resolution.
The dirt snaps into the planter, the stem(s) screws into the dirt and the tulip screws onto the stem.
Do not scale down or the threads will not work! Print at a fine layer height such as .16mm.
I recommend the springy dirt be made out of ABS with 3 wall loops if possible or it might sag over time.
No supports are required.
The models shown were printed with ABS using a .16mm resolution.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!