Thingiverse
Tuning fence
di Aravon
1
Download
1
Likes
0
Makes
I design this to test the best settings for new filaments with minimal material to save time and cost.
You can run this as a torture test too. (so the name fence of death)
Start from higher temperature then try lower the temperature every 5-10 degrees to see the results. You can adjust other settings for retraction, speed, etc. But I recommend playing with temperature first.
I found out the best temp. for my new PLA filament was in fact 175 degree to give the finest detail.
Print with a small brim for stability.
You can run this as a torture test too. (so the name fence of death)
Start from higher temperature then try lower the temperature every 5-10 degrees to see the results. You can adjust other settings for retraction, speed, etc. But I recommend playing with temperature first.
I found out the best temp. for my new PLA filament was in fact 175 degree to give the finest detail.
Print with a small brim for stability.
Aravon pubblica anche su
20 modelli aggiuntivi su altre 2 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
