Thingiverse
Turbine blower
von nfmeola
6
Downloads
2
Likes
0
Makes
My turbine blower.
After print I found that the cap is to small. make it a little bit bigger in the slicer (about 102%) or fix the model before print.
I tested it with 30000 RPM with a dremel and it didn't break. It made a huge wind.
I'm not fully happy with it, so maybe i'll do better next time.
Have fun.
After print I found that the cap is to small. make it a little bit bigger in the slicer (about 102%) or fix the model before print.
I tested it with 30000 RPM with a dremel and it didn't break. It made a huge wind.
I'm not fully happy with it, so maybe i'll do better next time.
Have fun.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
