Engineering
Ver Modelo
turbojet engine compressor shroud
4
Descargas
5
Likes
0
Makes
This is the intake and compressor shroud from my prototype turbojet engine. designed around an old turbo impeller, this compressor assembly was able to make a jet engine self-sustain for more than 3 minutes. However, it is only 3D printed and like the bearings, it eventually succumbed to the heat. I have a model of the impeller, but the one I used was made of titanium and was much more well equipped for the high-speed compression forces.
I have included models of many of the primary components, as well as a few others that were not used in this project specifically.
I have included models of many of the primary components, as well as a few others that were not used in this project specifically.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!