Thingiverse
TurboWing Cyclops 2 Mount
von pwnd
29
Downloads
23
Likes
0
Makes
I designed a simple mullet mod mount for the TurboWing Cyclops 2 AIO so I can finally properly mount my fav whoop camera. Put a slim strip of sticky tape on the underside of the camera so it will fit tightly. The mount is designed to fit the TinyWhoop canopies.
V2: Improvements so that the camera doesn't get lose over time. Also, the VTX holder is thicker now, but it can still break in hard crashes. It's advised to also use some sticky tape to secure the VTX.
V3: Further increased the thickness to make it even more durable.
V2: Improvements so that the camera doesn't get lose over time. Also, the VTX holder is thicker now, but it can still break in hard crashes. It's advised to also use some sticky tape to secure the VTX.
V3: Further increased the thickness to make it even more durable.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
