Turnigy 9XR Multi-Protocol Module Case

A module case for the DIY 4-in-1 multi-protocol module which allows use of the Turnigy 9XR Pro's internal antenna.

To use this case you may need to modify your multi-protocol module - I had to remove the 5-pin header connector from its original position on top of the board and re-solder it underneath. This was done to ensure a good connection with the module bay pins.

As I use my module in serial mode I also removed the bind button so that I could have a completely flush cover plate.

You will need an MCX to IPX/U.FL antenna cable, like this:
http://www.ebay.co.uk/itm/262040276984

In truth 15cm is slightly too long, but the extra coax can be easily looped under the board. 7.5-10cm would probably be better.

I'm still tweaking and fine-tuning, but the parts are essentially functional at this point.

Update:
I've published a version for the newer STM32 board:
https://www.thingiverse.com/thing:2788944