Turntable for 3D scanning

Turntable for 3D scanner.
What will be needed: 4x screws M6x 20mm
4x screw M3x 15mm
1x 220V clutch
1x cable with 220V socket
4x locking washer ´
You bought 1x stepper motor 0.8-1 revolutions per minute, it on Amazon
https://www.amazon.co.uk/dp/B07FTGD51D?psc=1&smid=AT1Q9BWPH6Y68&ref_=chk_typ_imgToDp

It took me 16 hours to print all the parts
Assemble everything according to the photo.
It's nothing difficult. You will need: M6 and M3 taps and a drill with a diameter of 6 and 7 mm

Procedure: print all the parts, put on the rolls, it will be necessary to drill the inner holes with a 6 mm drill and make an M6 thread from both sides in the lower part where the rolls will be put on, put the tool for centering the motor on the motor, center it so that the motor is in the ideal center. Drill 3 mm hole holes in the motor t