Slicer Discord
Turtle Climbing Platform – 3D-Druckmodell von MakerWorld MakerWorld
Pets

Turtle Climbing Platform

225 Downloads
52 Likes
81 Makes
Zum Modell
This is a platform for any smaller pets to climb up or go under. There are several .1in x .1in squares on the ramp for grip to make it easier for the animal to climb up on. I also made several .02in groves at the top of the platform to give the animal more grip as well as make it look better and for a place for water to drain out. I also made a version for a 5.5-gallon tank that is slightly longer and has a water dish insert that you can print. The model with the water dish fits on the smaller side of the 5.5-gallon tank perfectly. The water dish is removable to change the water more easily. The largest of the platform option still is able to fit on the short side of a 5.5-gallon tank. The largest option also has a less steep ramp which makes it much easier for any animal to climb up. If you are printing either of the ones with ought the dish holder, I would recommend you use an outer brim as well as set the bed temperature around 75F to keep the edges from warping. There should not ne
Kategorie
Pets
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

Madary Prints veröffentlicht auch auf

3 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen