Turtlebeach VelocityOne Yoke - Binding Fix

The Turtlebeach VelocityOne Yoke feels sometimes quite sticky, when you change the pitch axis of the plane by pulling or pushing the yoke.

This Youtuber has shown a solution to fix this problem by adding a guide for the steering rod:

https://youtu.be/NdvGwvHSPTQ?si=qtVSM0WQv0FHpWrm

Since I didn't want to spend money on an STL file, I took the 30 minutes in Freecad to design the bracket by my own.

I printed the bracked in ABS, but I think PLA should do it as well. For the V-slot-sleeve of the bearing I used TPU, but I don't think the material matters for this part either.

I used M5 screws to close the bracket. A clamping length of 20 mm should be sufficient. I cut off a piece of M8 threaded rod for the bearings. This can easily be screwed into the plastic of the 3D print by hand. Fixing with nuts or glue is not necessary.