Thingiverse
TUSH - One Piece "Push" Version
door kmccon
48
Downloads
31
Likes
1
Makes
This is a one piece version of Tush. Bearings (608's) are pushed up through the holes in the bottom of the bracket and then they snap in place.
It takes a little concentration to get them snapped into the center of the bearing. They snap easily over the outer race, but get a little tougher snapping into the inner race.
Bearings can be removed by continuing to push up out of the snap features.
I kept the infill low to allow better flexing of the snap features.
Also attached is the step file for the bracket.
It takes a little concentration to get them snapped into the center of the bearing. They snap easily over the outer race, but get a little tougher snapping into the inner race.
Bearings can be removed by continuing to push up out of the snap features.
I kept the infill low to allow better flexing of the snap features.
Also attached is the step file for the bracket.
kmccon publiceert ook op
34 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
