Thingiverse
Tush stand
von DividedPage
27
Downloads
10
Likes
1
Makes
A stand for the TUSH spool holder.
I made this model as the way I had my filament it would make the TUSH slide or fall apart,
and a lot of other designs dont have a back on the stand and aren't as easy to put screw holes in.
I made a second file for ones with holes for mounting and a 3rd with a single centre hole,
to keep the stands in place this design is fine by itself but if you want a bit more of a rigid solution you could stick rubber feet to the bottom or screw them down.
I made this model as the way I had my filament it would make the TUSH slide or fall apart,
and a lot of other designs dont have a back on the stand and aren't as easy to put screw holes in.
I made a second file for ones with holes for mounting and a 3rd with a single centre hole,
to keep the stands in place this design is fine by itself but if you want a bit more of a rigid solution you could stick rubber feet to the bottom or screw them down.
DividedPage veröffentlicht auch auf
3 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
