TUSH V-Ring Mod (minimal change)

The original TUSH is an absolute minimalistic masterpiece but I had an issue with grinding of the spool against the sides of TUSH. To fix this, I enlarged the whole upper portion with carriers for the bearings upwards by about 3mm to support 608/zz608-bearings with a press fitted V-ring for spool centering.

To support TUSH at a spool width of either around 58mm or 50mm (running center to running center), there are spacers incuded in the parts.

If you need a different spacer width for your spool just comment and I'll add it.

___

*Parts list for full setup:*
- 4x TUSH Mod
- 4x V-ring from this: https://www.thingiverse.com/thing:3052488
- 2x TUSH Spacer 58mm

*Optional:*
- CA glue

___
*Assembly Instructions for one side (step 3 is optional):*
1. Fit a V-ring flush onto a 608 bearing, repeat this for one more bearing.
2. Take 1 TUSH Mod piece and set both V-ring fitted 608 bearings in place.
3. Put a small (!!!) drop of CA glue on each of the TUSH Mod surfaces in