Twinkly Matrix Mount

Bought a twinkly matrix light but it only came with 1 used mount without adhesive. Ended up making two versions, though neither is perfect I admit.
v1 is a close likeness to the original, but does not distance the bar off the wall very far, so it hugs closer. It also has a hole for a screw as intended in the original version.
v2 is modified to take 1/4 of a 60x60mm "nanotape" adhesive I had purchased from aliexpress, so it's dimensions are fairly square at 30x30mm. The bar now properly sits further away from the wall as the original, but lacks the mounting hole for a screw for more surface area for the adhesive. If push comes to shove I may make a v3 or other version that would work better for someone's specific use case. V2 snaps very firmly, while V1 might have a little bit more play in tolerances.

I personally printed in PETG but PLA should work just fine too, 30% gyroid infill, 3 walls.