Twisted Vase - Vase Mode

Best to be printed with PETG as spiral vase, no support needed, uses only 33gr. filament.easy settings to print a watertight object in spiral vase mode; 1- PETG recommended since when in contact with water it performs much better comparing to pla or pla derivatives.2- Edit your filament settings in slicer and increase flow ratio to 1.2,3- Set all “line width” settings to 2x your nozzle allows (0,8mm lines for 0,4mm nozzle, or 1,2mm lines for 0,6mm nozzle etc.)4- Smaller layer height brings better watertightness. 0,16mm layer height is fine for 0,4mm nozzle, 0,2mm layer height is ok for 0,6mm nozzle etc…)5- printing 5 degree celcius hotter generally helps, but depends very much on the filament. Model is suitable for printing in normal mode but its harder to make watertight and uses more filament.