Thingiverse
Twister v3 - Phone Elevator
von paul_down_south
0
Downloads
0
Likes
0
Makes
I made this as a phone stand when video calling the kids. I was keen to make it a print in one task, which was fun. It was designed in OpenScad.
It prints well on my Creality 3 V3, using PLA.
Do not use supports - they are not needed and will spoil it.
Like many single prints, with narrow gaps, it will require a little encouragement to first move - but be brave - and it will work.
Here is a video. Not sure if video share is allowed, will delete if not.
https://1drv.ms/v/c/db53006fba7cff14/IQC6_qRkT_4PTKATKjw-hJLKAex8EFwXnuxEHxghCSEQXIE?e=9OzVyL
It prints well on my Creality 3 V3, using PLA.
Do not use supports - they are not needed and will spoil it.
Like many single prints, with narrow gaps, it will require a little encouragement to first move - but be brave - and it will work.
Here is a video. Not sure if video share is allowed, will delete if not.
https://1drv.ms/v/c/db53006fba7cff14/IQC6_qRkT_4PTKATKjw-hJLKAex8EFwXnuxEHxghCSEQXIE?e=9OzVyL
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!