Slicer Discord
Two sided point counter dials – 3D-Druckmodell von Thingiverse Thingiverse

Two sided point counter dials

133 Downloads
74 Likes
1 Makes
Zum Modell
This is a two sided HP or damage counter for use in board games, card games and the like. The numbers range from 1 to 10 on one side and 11 to 20 on the other side. You can stack several to account for more than 20. When you are counting up or down and you pass 10 or 1 (or 20 or 11), just flip the disk over and keep counting since the one's digits will match both sides.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen