Thingiverse
Two-stage planetary gearbox
von Milos3331
96
Downloads
79
Likes
0
Makes
Planetary gear with gear ratio 9.
supports used:
Carrier-part1
Case-part1
Non printed parts:
Steel rods (8mm diameter)-
carrier: 39.5mm (6x)
shafts: 75mm, 75mm
casing: 24mm (3x), 22mm (3x)
wire: 1,5mm diameter - 14 mm lenght (2x)
screws: M6-28 (3x), M6-20 (3x)
nuts: M6-5 (6x)
Bearings- 15x32x8 (2x)
Materials:
Casing parts- PLA
Mechanically stressed parts- PET-G
supports used:
Carrier-part1
Case-part1
Non printed parts:
Steel rods (8mm diameter)-
carrier: 39.5mm (6x)
shafts: 75mm, 75mm
casing: 24mm (3x), 22mm (3x)
wire: 1,5mm diameter - 14 mm lenght (2x)
screws: M6-28 (3x), M6-20 (3x)
nuts: M6-5 (6x)
Bearings- 15x32x8 (2x)
Materials:
Casing parts- PLA
Mechanically stressed parts- PET-G
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
