Two Trees SK1 Camera Mount

This is a 2 or 3 part print, based on your camera mounting needs.
This uses the Two Trees holes in the case for mounting the camera.

Minimum hardware needed, 3 M3x8 bolts, hinge point is designed for caphead.

if your camera mounts with a 1/4-20 bolt, you will need one at 1/2" long to fit properly, and not be too long or too short.

If you have heatserts, the M3x6 will fit into all 3 holes in the heatsert camera base.

The nosert prints are for those who have M3 hardware, and holds sufficiently on first attachement, but I make no promises for hole reuse if it needs to be removed repeatedly.

The elp is for the camera series with [40mmx40mm sides backer boards](https://www.amazon.com/gp/product/B07MSDYQR3/), and requires 4 M2x8 bolts, and if using heatserts any up to 4mm in length will work.

the 0.25-20 is the 1/4-20 mount for cameras with a 1/4"-20 thread hole to mount them by, like the Logitech C615 which also may need the spacer washer to get the mount to be flat to th