TwoTrees SP-5 upgrade

This is a project to upgrade the TwoTrees SP-5 3D printer.

I cut the side covers and cap on my CNC router from aluminum composite panels 3 millimeters thick. The doors and the front wall of the hood are made of 3 mm acrylic.
I made the cap 20 millimeters wider than you can see in the video, so that there was more space inside for the cable. I also used a factory upgrade kit from the manufacturer with a new board and a direct extruder.
Along the edges, the side covers are screwed to the frame through T-nuts, and for the central part in the frame you will need to drill holes and cut an M4 thread. The same goes for the back wall and doors - you need to drill and tap an M4 thread.

Update 26.04.25
The printer has the Klipper firmware installed, and some parts have been replaced, all links below.
The configured config has been added to the files section.

Assembly video - https://www.youtube.com/watch?v=nfBwpolIjpM
Upgrade Video - https://www.youtube.com/watch?v=Ct7-COZtG8Q

List of compon