Thingiverse
TX16S Neck Strap Balancer
por MuninnFPV
35
Descargas
24
Likes
0
Makes
The TX16S is a little heavy on the bottom, this neck strap balancer is made to shift the weight up slightly.
Print without supports, & 100% infill for strength.
Use brim when printing.
Read below before printing!
* I made the pins with very littler tolerance, make sure your temp is not to high so to avoid over-extrusion.
* Make sure to file the pin holes so the pin slides in with slight friction.
* Some filing will be needed to make surfaces are as flat as possible ( it took me 5 min to file the interfaces smooth so they fit snuggly).
Print without supports, & 100% infill for strength.
Use brim when printing.
Read below before printing!
* I made the pins with very littler tolerance, make sure your temp is not to high so to avoid over-extrusion.
* Make sure to file the pin holes so the pin slides in with slight friction.
* Some filing will be needed to make surfaces are as flat as possible ( it took me 5 min to file the interfaces smooth so they fit snuggly).
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
