Tybalt the Garden Gnome... SPLIT!

Tybalt the Garden Gnome, by itech3dp. I split him so he can be printed with minimal supports, and twice the size if you print each half separately!

I use Cura 3.6+ with Experimental>Tree Supports as this is the easiest supports to remove once dialed in. His nose, boots & the back of his hat need the support mainly.

+=+=+=+=+=+=+

I did further splitting so you can actually print him in 4 different pieces, all oriented flat on the print bed, with no supports necessary. More time consuming? Yes. No supports though, because I HATE supports!

Pro Tip: Once he is printed & super glued together, put baking soda in the seam & then drip super glue in to it. Wait a few minutes & then sand smooth.

Then he can be painted!

Thanks to itech3dp for the awesome model!