U7 In-Wall Paintable Flush Mount

✨ What It DoesUltra Low-Profile: Mounts your UniFi AP just a few millimeters proud of the wall.Plaster-Ready Lip: 1 mm rounded “feather edge” lets you skim drywall compound right over the trim.Secure Mounting: Brass M4 threaded-insert pockets hold your AP rock-solid with countersunk bolts.Snap-On or Magnetic Cover: Optional recesses for eight 7 × 3 mm neodymium magnets—no ugly clips or gaps.Minimal Signal Loss: Tested at 1 Gbps across a 1,500 ft² open room with full Wi-Fi throughput.🔧 You’ll Need(Hardware not included; pick these up at any electronics or hardware store)2× M4 × 4 × 6 mm brass knurled (female) threaded inserts2× M4 × 6 mm flat-head countersunk boltsOptional: 8× 7 × 3 mm neodymium magnets🖨️ Print & Install TipsOrientation: Print the frame and cover face-down (flat base to the plate) for best surface finish.Material: PLA, PETG, or ASA all work well—just use a primer before plastering.Heat-Set Inserts: Use a soldering iron or dedicated heat-set tool to press inserts into