Thingiverse
Ubiquiti Unifi Cloud Key CK Controller Mount
by Printbus
104
Downloads
50
Likes
1
Makes
The openSCAD script provides a configurable mounting bracket for use with the Ubiquity Unifi Cloud Key (UCK) Controller. Product link: https://www.ubnt.com/unifi/unifi-cloud-key/
NOTE: This item fits the smaller of the products in the cloud key product line, not Generation 2 or 2+. More specifically, the design was created for and verified with an older version using a micro-USB connector.
The bracket can be prepared so that the UCK is mounted in a lay-flat configuration, or in an upright, on-edge configuration. The top-level geometry section of the script allows the user to specify the desired openSCAD result. Two components are provided. One serves as a wrap-around for the UCK, and the second component serves as a base.
The wrap component can be configured with a closed bottom and used alone for a low-profile mount. Configuring the wrap component with an "open" bottom allows it to be "sprung" over the UCK. Here, use of the base component can be used to help stabilize the op
NOTE: This item fits the smaller of the products in the cloud key product line, not Generation 2 or 2+. More specifically, the design was created for and verified with an older version using a micro-USB connector.
The bracket can be prepared so that the UCK is mounted in a lay-flat configuration, or in an upright, on-edge configuration. The top-level geometry section of the script allows the user to specify the desired openSCAD result. Two components are provided. One serves as a wrap-around for the UCK, and the second component serves as a base.
The wrap component can be configured with a closed bottom and used alone for a low-profile mount. Configuring the wrap component with an "open" bottom allows it to be "sprung" over the UCK. Here, use of the base component can be used to help stabilize the op
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
