Thingiverse
UFO Bookends
von Conceptus3D
164
Downloads
142
Likes
1
Makes
Print your very own stick figure abduction!
I've put all the files together for those that want to be able to "plug & play".
No support needed if printed in current orientation. I generally always use a raft with my prints to [drastically] increase success rate, but it would probably print fine without raft if you're freshly calibrated.
Individual pieces can be found here: http://www.thingiverse.com/thing:1132278 if you'd like to change the scale.
1st file is a little thinner and works fine on a bookshelf as an actual bookend. 2nd file is thicker/heavier and works well on a bookshelf or as a standalone piece for a few books on your desk.
GO NUTS COSMONAUTS
I've put all the files together for those that want to be able to "plug & play".
No support needed if printed in current orientation. I generally always use a raft with my prints to [drastically] increase success rate, but it would probably print fine without raft if you're freshly calibrated.
Individual pieces can be found here: http://www.thingiverse.com/thing:1132278 if you'd like to change the scale.
1st file is a little thinner and works fine on a bookshelf as an actual bookend. 2nd file is thicker/heavier and works well on a bookshelf or as a standalone piece for a few books on your desk.
GO NUTS COSMONAUTS
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
