Thingiverse
UHF Satcom Antenna
von Die_Bastelkammer
425
Downloads
332
Likes
0
Makes
This is a re-design of the popular DIY UHF Satcom antenna which was published several years ago in the special interest magazine MONITORING TIMES.
The so called „MT Omni X-wing“ antenna was designed for a fixed setup. My Re-design is more like the commercial antennas in use by the army. The antenna is mounted onto an ordinary camera tripod, instead of a fixed mesh ground reflector. The mesh is replaced by 6mm radials as reflector.
The mounting of the two dipoles is covered with a printed housing. The housing can hold a director boom, if someone need it.
More about the details of my re-design can be found on my blog: http://diebastelkammer.wordpress.com
I whish everyone a good re-build
73
The so called „MT Omni X-wing“ antenna was designed for a fixed setup. My Re-design is more like the commercial antennas in use by the army. The antenna is mounted onto an ordinary camera tripod, instead of a fixed mesh ground reflector. The mesh is replaced by 6mm radials as reflector.
The mounting of the two dipoles is covered with a printed housing. The housing can hold a director boom, if someone need it.
More about the details of my re-design can be found on my blog: http://diebastelkammer.wordpress.com
I whish everyone a good re-build
73
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
