Thingiverse
Ukiyo130 : canopy
par nracing
71
Téléchargements
77
Likes
0
Makes
updates :
29/04/2018 : camera mount slot added with smaller insert.
Canopy for Ukiyo130 by NRACING FPV (www.nracing-fpv.com).
Designed for the runcam micro swift, linear antenna and rx antenna on the side by using antenna tubes.
The camera may touch a bit the 20x20 stack on the first version of the frame (before october 2017).
On the new version of the frme the stack is a bit backward.
The canopy can be print horizontally but as you need support, half of the filament will be waste.
You can print it vertically, it will be twice faster and almost no support. However the front of the canopy wont be really clean, and you really need good print settings to make it possible (nice challeng, isn't it ? :D ).
29/04/2018 : camera mount slot added with smaller insert.
Canopy for Ukiyo130 by NRACING FPV (www.nracing-fpv.com).
Designed for the runcam micro swift, linear antenna and rx antenna on the side by using antenna tubes.
The camera may touch a bit the 20x20 stack on the first version of the frame (before october 2017).
On the new version of the frme the stack is a bit backward.
The canopy can be print horizontally but as you need support, half of the filament will be waste.
You can print it vertically, it will be twice faster and almost no support. However the front of the canopy wont be really clean, and you really need good print settings to make it possible (nice challeng, isn't it ? :D ).
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
