Thingiverse
Ukulele Wall Holder
door Dr4l3g
1
Downloads
2
Likes
0
Makes
Hello,
This is a ukulele holder.
I use 2 parts with one print twice to have the more strong holder possible (for me).
My soprano and my tenor have 38mm of width for the fretboard, this holder is made for 40mm of width fretboard.
So, there is the base to print once and the arm to print twice.
There is two hole for screws (about 4mm width)
All horizontally without support.
UPDATE:
- I add a "little" base with less material so
- I made a bevel version for base a little-base.
- I add a long arm for ukulele with deep mechanic.
This is a ukulele holder.
I use 2 parts with one print twice to have the more strong holder possible (for me).
My soprano and my tenor have 38mm of width for the fretboard, this holder is made for 40mm of width fretboard.
So, there is the base to print once and the arm to print twice.
There is two hole for screws (about 4mm width)
All horizontally without support.
UPDATE:
- I add a "little" base with less material so
- I made a bevel version for base a little-base.
- I add a long arm for ukulele with deep mechanic.
Dr4l3g publiceert ook op
3 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!