Thingiverse
Ultimaker - Polybox Adapter
von 1337Slewis
1
Downloads
0
Likes
0
Makes
I needed a solution to secure the tubing near the opening of feeder unit without fuss.
This jockeys off the 2 lower bolts in the feeder unit, snugly fitting in place.
The tubing is held by a 10mm minor interference fit, NO DAMAGE to tubing.
You will need two slightly longer bolts, the 20mm variant, per feeder unit.
The original file is for Feeder Unit 1, left side when facing the machine front.
Simply mirror the file for the other side.
Also included is a tube fastener for the PolyBox itself, to keep the tubes perpendicular to the box, and prevent damage from tubing pulling at weird angles.
This jockeys off the 2 lower bolts in the feeder unit, snugly fitting in place.
The tubing is held by a 10mm minor interference fit, NO DAMAGE to tubing.
You will need two slightly longer bolts, the 20mm variant, per feeder unit.
The original file is for Feeder Unit 1, left side when facing the machine front.
Simply mirror the file for the other side.
Also included is a tube fastener for the PolyBox itself, to keep the tubes perpendicular to the box, and prevent damage from tubing pulling at weird angles.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
