Thingiverse
Ultimate Belt Clamp
von Deafshot
2
Downloads
1
Likes
0
Makes
Probably the strongest 3d printed GT2 belt clamp so far. Uses wedges to clamp the belt tighter the harder its pulled. In fact, its so strong you probably don't even need it. You should try my "Almost Ultimate Belt Clamp" first, which is less than 1/2 the width.
Place the outer portion over the belt first, then wrap the belt around the inner portion. After this is done, Push the inner portion into the outer part. Tension your belt as tight as you want.
The only down side to this design is that its a little chunky.
Place the outer portion over the belt first, then wrap the belt around the inner portion. After this is done, Push the inner portion into the outer part. Tension your belt as tight as you want.
The only down side to this design is that its a little chunky.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
