Thingiverse
Ultimate clearance calibration test
por energywave
543
Descargas
251
Likes
6
Makes
This is the ultimate calibration test to print to understand how much clearance you must leave between two parts to not melt them in a whole object.
Print it and press the pins in descending order (from lower right, going left, then middle right going left, at last first line going left). The last pin you can detach (without a hammer :) is the one identifying the minimum space you must leave between objects in your designs to not print a whole block.
The clearance of the pins are as follow:
(0.2mm) (0.3mm) (0.4mm)
(0.5mm) (0.6mm) (0.7mm) (0.8mm)
(0.9mm) (1.0mm) (1,1mm)
Print it and press the pins in descending order (from lower right, going left, then middle right going left, at last first line going left). The last pin you can detach (without a hammer :) is the one identifying the minimum space you must leave between objects in your designs to not print a whole block.
The clearance of the pins are as follow:
(0.2mm) (0.3mm) (0.4mm)
(0.5mm) (0.6mm) (0.7mm) (0.8mm)
(0.9mm) (1.0mm) (1,1mm)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
