Thingiverse
Ultimate Spool Holder Holder
door OkuruFPV
114
Downloads
68
Likes
0
Makes
I designed this end for the TUSH ultimate spool holder to keep it from toppling over. It fits nicely if your dimensions are dialed in.
http://www.thingiverse.com/thing:2047554
The 57mm version is meant to fit a spool with an average width of 57mm. (SUNLU)
The 47mm version is meant to fit a spool with an average width of 47mm. (PolyFlex)
Make two, one for each end.
The file SpoolPad.stl is for the bottom. Print this with TPU and hot glue it to the bottom to keep them from sliding.
http://www.thingiverse.com/thing:2047554
The 57mm version is meant to fit a spool with an average width of 57mm. (SUNLU)
The 47mm version is meant to fit a spool with an average width of 47mm. (PolyFlex)
Make two, one for each end.
The file SpoolPad.stl is for the bottom. Print this with TPU and hot glue it to the bottom to keep them from sliding.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
