Thingiverse
Ultimate spool holder - remix
von giacomozema
45
Downloads
33
Likes
1
Makes
This is a remix for the TUSH ultimate spoolholder model by filamentry.
I added a sleeve for the bearing that has the purpose of keeping the spool in the middle of the bearing because I noticed that it would slip to the edge and rub against the side of the spool holder.
I suggest to increase or decrease the scale by 1 or 2 percentages in the slicer to better fit the tolerances of your 3d printer.
I added a sleeve for the bearing that has the purpose of keeping the spool in the middle of the bearing because I noticed that it would slip to the edge and rub against the side of the spool holder.
I suggest to increase or decrease the scale by 1 or 2 percentages in the slicer to better fit the tolerances of your 3d printer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
