Slicer Discord
Ultimate Traxxas TQi controller RAM mount – 3D-printbaar model van MakerWorld MakerWorld
Robotics

Ultimate Traxxas TQi controller RAM mount

door SlawoFu · Robotics
8 Downloads
6 Likes
3 Makes
Model downloaden
If you need to mount your phone, camera, or any other device on your Traxxas TQi controller get that model and print it out!It's a popular mount used for offroad devices, phone holders for bikes, motorcycles, etc.The ball mount is at 30° angle, allowing you to navigate your RC model freely.You gonna need some longer screws, hot glue, or any other glue if you want to make it permanently mounted to your controller.If you decide to use screws, you need to find a set of two 40x4 mm (the original ones are too short). Additionally, two-sided tape between the mount and controller can stiffen out the whole setup.Print standing on the longest side, minimal supports are required.Printer parameters:material: PETG, or any other strong and elastic material,wall loops/perimeters: 8+infill: 40%+ gyroidsupports: YES, on a build plate onlyscrews: two 40x4 mm (max length 45x4 mm - if needed)
Categorie
Robotics
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Waarom?
uitgebreide nabewerking
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 2/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA, PETG
Nabewerking
Lijmen, Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

SlawoFu publiceert ook op

18 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie