Thingiverse
Ultitop Filter
von Marc_M
29
Downloads
21
Likes
0
Makes
This is a Filter and Fan housing for the Ultitop Cover.
For a better print with ABS and other strong smell Filament.
Its work really Fine and i have much less smell!
I have used PLA
You must print 2x Filter Holder, 2x The Safety Pin and the another STL Files only 1x.
Print in original Orientation and you need no support!
Material you need and I used:
Ultitop Cover*:
Remove the middle acrylic glass I used this:
Filter*:
Important! Remove the duct Tape from The Filter
Fan*:
Front Door*:
For a better print with ABS and other strong smell Filament.
Its work really Fine and i have much less smell!
I have used PLA
You must print 2x Filter Holder, 2x The Safety Pin and the another STL Files only 1x.
Print in original Orientation and you need no support!
Material you need and I used:
Ultitop Cover*:
Remove the middle acrylic glass I used this:
Filter*:
Important! Remove the duct Tape from The Filter
Fan*:
Front Door*:
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
