Slicer Discord
Ultra sonic sensor electronics housing – Modèle 3D imprimable de MakerWorld MakerWorld
Electronics

Ultra sonic sensor electronics housing

1 Téléchargements
0 Likes
0 Makes
Voir le modèle
This is a case for the electronics components used for the ultrasonic sensor that is featured in a Youtube video by KPeyanski.The case is designed to house the ESP8266 D1 mini and the control board part of the waterproof ultrasonic sensor (Amazon link below). The case could likely be shrunk down a bit but my soldering skills wouldn't let me get the wires connecting the two boards much shorter so this works great. There are supports on the floor of the case to hold the control board off the bottom and a ledge it fits under to keep it from rising up once everything is installed. The D1 mini slots perfectly into the lid and then just drop everything inside the case. The case IS NOT waterproof, just the sensor end. So please take care not to place this case in a location open to excessive moisture. Watch the youtube video for wiring and programming information, he makes it a breeze. Links for D1 mini and the ultrasonic sensor:https://www.amazon.com/dp/B08MKLRSNH?ref=ppx_yo2ov_dt_b_fed_
Catégorie
Electronics
Source
MakerWorld
Publié
Mis à jour
Ce qu'il faut pour imprimer: Débutant Confiance faible
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 0/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
PLA
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection