Thingiverse
Ultrasonic Sensor Waterproof Box
por M_Khan
3
Descargas
0
Likes
0
Makes
This is the waterproof box to house the ultrasonic distance sensor. To learn more about the this project, visit https://www.instructables.com/DIY-Ultrasonic-Distance-Sensor/.
Print specifications for the box:
Infill- >70% for longevity and protection against water seepage
No supports or adhesion needed
I used Black Tough PLA filament and layer height of 0.1 mm ("Fine" present on the Ultimaker S5)
The box has a waterproof top but to ensure waterproofing and for outdoor mounting, the box is sealed with four screws. The dimensions for the screws, wingnuts, and washer are:
Four 10-24 x 4” screws
Four 10-24 wingnuts
Four #8 washers
Designed by Muhammad Khan
Freshman Research Initiative Maker Space Stream at The University of Texas at Austin
Print specifications for the box:
Infill- >70% for longevity and protection against water seepage
No supports or adhesion needed
I used Black Tough PLA filament and layer height of 0.1 mm ("Fine" present on the Ultimaker S5)
The box has a waterproof top but to ensure waterproofing and for outdoor mounting, the box is sealed with four screws. The dimensions for the screws, wingnuts, and washer are:
Four 10-24 x 4” screws
Four 10-24 wingnuts
Four #8 washers
Designed by Muhammad Khan
Freshman Research Initiative Maker Space Stream at The University of Texas at Austin
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
