Thingiverse
UM2E+ Filament Guide
von forrestwhitmore
2
Downloads
1
Likes
0
Makes
Note: This has only been tested on the UM2E+. I am not sure if the other UM models have the same feeder assembly.
Designed to keep the feeder gear from slipping due to the tight spiral when the spool gets low. It helps keep the filament straight while feeding.
It’s really simple to install:
• Unload the filament
• Unscrew two (2) screws to remove the feeder housing
• Place the part around the feeder housing
• Tighten screws
• Reload filament
Designed to keep the feeder gear from slipping due to the tight spiral when the spool gets low. It helps keep the filament straight while feeding.
It’s really simple to install:
• Unload the filament
• Unscrew two (2) screws to remove the feeder housing
• Place the part around the feeder housing
• Tighten screws
• Reload filament
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
