Umarex HDS 68 Rib Riser

The rib on the HDS is purely decorative as the barrel selector obscures it in use. This rises the rib by an additional ~5mm and adds a small "bead" front sight.

It comes in two parts, the barrel shroud/rib and the action shroud/rib.

The barrel shroud is attached by:

* Removing the screw under the muzzles.
* Sliding the shroud over the barrels
* Screwing the muzzle screw back in.

The action shroud is attached by

* Removing the two screws holding in the rear rip
* Clipping the new shroud over
* Using two new M3 bolds to hold in place.


Use the "Snug Fitting Barrel Band" to check the size before printing the two shrouds.


*THIS IS WORK IN PROGRESS*
NOTE: There is a roughly 4mm gap between the barrel and the action shrouds, as well as other minor issues.
NOTE: This is the shroud only, not the stock.

Designed in TinkerCad:

Snug fitting band:
https://www.tinkercad.com/things/90in5zqflyO

Rib Riser (barrels):
https://www.tinkercad.com/things/dxe9jeNi2