Thingiverse
Umbrella handle
von DucaMerlin
0
Downloads
1
Likes
0
Makes
Replacement umbrella handle
I created this replacement for a handbag umbrella.
External measurement 49mm x 29mm
It accommodates 8.4mm x 5.80mm oval section rods
It is fixed with a 3mm x 25mm self-tapping screw with a conical head, in the remaining broken section of the old handle (suitably drilled with a 3mm bit)
If there are no parts to anchor the screw, use two-component glue or similar.
Printed with 0.2mm PETG
Without supports
I created this replacement for a handbag umbrella.
External measurement 49mm x 29mm
It accommodates 8.4mm x 5.80mm oval section rods
It is fixed with a 3mm x 25mm self-tapping screw with a conical head, in the remaining broken section of the old handle (suitably drilled with a 3mm bit)
If there are no parts to anchor the screw, use two-component glue or similar.
Printed with 0.2mm PETG
Without supports
DucaMerlin veröffentlicht auch auf
21 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
