Thingiverse
Under desk drawer
door chimeranzl
10.2k
Downloads
7.3k
Likes
24
Makes
If you are after a smaller under desk swivel tray, check out my other design here:
https://www.thingiverse.com/thing:4617797
Under desk drawer system. Screw the runners under your desk, choose a version of drawer to print and slide it on the runners. Standard drawer dimensions 200mm long, 120mm wide, 60mm deep. Designed so no supports are needed when printing. I have allowed a little bit of play between runners and drawers, so it doesn't "stick" when opening.
Good for storing small items (pens, paper clips, staples, etc) to keep your desk tidy.
drawer-v1 = no divider (single partition) - black/purple photo
drawer-v2 = width divider (two partitions) - black/yellow photo
drawer-v3 = length divider (two partitions)
drawer-v4 = width and length divider (four partitions)
-extra-large.stl, drawer 350mm long, 200mm wide
-half-height.stl, drawer approx 30mm high
-mini, drawer 150mm long, 150mm wide
-wide, drawer 150mm long, 200mm wide
Runners v2: These are 1mm shorter t
https://www.thingiverse.com/thing:4617797
Under desk drawer system. Screw the runners under your desk, choose a version of drawer to print and slide it on the runners. Standard drawer dimensions 200mm long, 120mm wide, 60mm deep. Designed so no supports are needed when printing. I have allowed a little bit of play between runners and drawers, so it doesn't "stick" when opening.
Good for storing small items (pens, paper clips, staples, etc) to keep your desk tidy.
drawer-v1 = no divider (single partition) - black/purple photo
drawer-v2 = width divider (two partitions) - black/yellow photo
drawer-v3 = length divider (two partitions)
drawer-v4 = width and length divider (four partitions)
-extra-large.stl, drawer 350mm long, 200mm wide
-half-height.stl, drawer approx 30mm high
-mini, drawer 150mm long, 150mm wide
-wide, drawer 150mm long, 200mm wide
Runners v2: These are 1mm shorter t
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
