Thingiverse
Under shelf rail and boxes
door Dudi3D
22
Downloads
40
Likes
0
Makes
This is a solution for storing small items like bolts, connectors etc. for us makers.
The rail was printed from PETG and the sleeve and box (black & orange) from PLA+
Sorry for the colours, I was short on supplies :-)
Enjoy!
Supports were used ONLY for the orange box since it has a little handle and a protected bottom rail.
The transparent rail was printed without any support and the black sleeve had been printed vertically so no support was required either.
The rail was printed from PETG and the sleeve and box (black & orange) from PLA+
Sorry for the colours, I was short on supplies :-)
Enjoy!
Supports were used ONLY for the orange box since it has a little handle and a protected bottom rail.
The transparent rail was printed without any support and the black sleeve had been printed vertically so no support was required either.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
