MakerWorld
Organizers
Zum Modell
Under Table Cable Management
113
Downloads
33
Likes
51
Makes
Simple under-the-table platform to hide all your cable mess from the floor. I created this model so that my vacuum robot can clean properly without getting tangled in wires. Since there are so many varieties of power bars and charging bricks, a simple extra platform under the table would do the trick. The model is created to be support-free. There is a single-layer film on the screw holes for support-free purposes. As it is only one layer, you can just force the screw through. Print two and connect the side without the perimeter wall together. Print at 0.28 layer height.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!