Under table headphone holder

I wanted to hang my headphones under the controller for my Flexispot. Unfortunately, I did not find what I was looking for on Printables, but discovered this model on Thingiverse. After printing (with a slightly smaller scale) the hanger was still a bit too long for me. Therefore, I have adapted this model a little and also taken my ideal scaling. The space for the headphone band is now about 3cm. The total length are about 9cm and the headphone hangs on 7cm.I hope you have fun with the model and if it should be a little longer go to the original model on Thingiverse.Printed without support with 15% infill.