Thingiverse
Underdesk cable holder
by BC3ds
21
Downloads
51
Likes
0
Makes
This is a underdesk cable holder out of 2 pieces, but prints from one file.
Max. cable diameter 7mm.
If 2nd piece is left away / flipped around, it reduces to 3.5mm / 2x 3.5mm.
Width for cables is 40mm.
Standard flathead wood screws to be used: 3.5x30mm to 4x30mm for both pieces used and 20mm desk plate.
Use 2nd file to print a gauge for placement of pre-drilled holes (2.6mm).
Distance will be 60mm from edge of the desk plate.
Hope you like it!
Best regards from
Bernd's Custom 3D's.
Max. cable diameter 7mm.
If 2nd piece is left away / flipped around, it reduces to 3.5mm / 2x 3.5mm.
Width for cables is 40mm.
Standard flathead wood screws to be used: 3.5x30mm to 4x30mm for both pieces used and 20mm desk plate.
Use 2nd file to print a gauge for placement of pre-drilled holes (2.6mm).
Distance will be 60mm from edge of the desk plate.
Hope you like it!
Best regards from
Bernd's Custom 3D's.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!