Thingiverse
Undermount desk side holder
by shimodesign
4
Downloads
4
Likes
0
Makes
Needed a good headphone holder so designed this one. And then made another one to hold my blue tape for my little Printrbot.
Uses countersunk #6 screws from the underside of the desk, with the arc designed to clear any tabletop bigger than half inch thick. Prints with no support material without issue.
I hit the raised letters with a quick coat of white paint to pop them out. The white letters on black material sorta feel like an old-timey radio microphone label.
Uses countersunk #6 screws from the underside of the desk, with the arc designed to clear any tabletop bigger than half inch thick. Prints with no support material without issue.
I hit the raised letters with a quick coat of white paint to pop them out. The white letters on black material sorta feel like an old-timey radio microphone label.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
