Thingiverse
Undershelf Rack
von xman5735
0
Downloads
1
Likes
0
Makes
A triple or single rack made to mount to the underside of a safe shelf to keep pistols off the shelf and protected.
Internal size is 6" deep, 5" tall, 2.25" wide top fit most pistols with holster.
Has cutouts for filament saving. Angled cutouts on top for geometric support, you do not need if you increase infill.
Hole size is 5mm for use with direct thread 6mm or reinforced with backing nut.
Infill: At least 15%
Material: Developed for PLA+
Support: No support if 70% overhang capable, otherwise tree method.
Internal size is 6" deep, 5" tall, 2.25" wide top fit most pistols with holster.
Has cutouts for filament saving. Angled cutouts on top for geometric support, you do not need if you increase infill.
Hole size is 5mm for use with direct thread 6mm or reinforced with backing nut.
Infill: At least 15%
Material: Developed for PLA+
Support: No support if 70% overhang capable, otherwise tree method.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
