Unicorn Light Cover

Originally started with inspiration from https://www.thingiverse.com/thing:2792176, I ended up going back to source and remixing a WALLY single switch wall plate and muzz64's Unicorn.

There are studs sticking out of the wall plate and matching indentations on the back of the unicorn to allow you to print the parts separately and then glue them together. I also filled in muzz64's unicorn, there was an odd hole under the neck and void throughout the middle that, when printed, gave the void section a rough appearance.

Update 8/7/2022: Apparently, the original design measurements I used were WAY off for the screw holes. I've measured off a standard size wall plate and adjusted the screw hole locations.