Slicer Discord
Unicorn nightlight battery pack – 3D-Druckmodell von Thingiverse Thingiverse

Unicorn nightlight battery pack

72 Downloads
76 Likes
0 Makes
Zum Modell
This is a battery pack for this nefarious night light with one 5mm led that runs with 3 1.5V LR44 batteries. An educated monkey crunches the numbers quite easily, getting an idea that this piece of..nightlight runs only a bit over 1 week with 3 small batteries.

My daughter received a pack of 2 of these as a bday present and of course i had to do something about this, (I don't want to spend ludicrous amounts of money for the batteries), so i designed a battery pack for 3 x AAA rechargeable batteries, ~1.2V a piece.

Wiring is pretty much no-brainer, use the switch on the positive lead and solder both wires to the original LR44 box terminals.

The project was a glorious success, semiflex model provides press-fit very well and holds both box and switch nicely. If you use hot glue for the switch take care not to get any glue to the side of the slide.

battery box i used(with diameters):
http://www.spelektroniikka.fi/p17982-paristokotelo-3-x-aaa-snap-lock-kansi-batbox45-fi.html
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Kleben
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

taeraeyttaejae veröffentlicht auch auf

40 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen