Thingiverse
Unicycle Valve Cap
von goboatmen
33
Downloads
30
Likes
3
Makes
Unicycle valve cap for your unicycle (or your dirty bike)
I printed in PLA at 185
The hole has a 1 degree taper, so just screw it on, it should work just fine for conventional inner tubes
I printed in PLA at 185
The hole has a 1 degree taper, so just screw it on, it should work just fine for conventional inner tubes
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
